Most of our Mount Vernon calls come from the US-43 corridor and Main Street, though we work the whole Mobile County side of it and get out to Prichard regularly.
Mount Vernon has enough older housing stock that repair almost always beats replacement here, and enough new construction that we spend a lot of time on hardware that failed early.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895What Mount Vernon customers call us about
These are the door hinge repair faults we are called out to most often in Mount Vernon. If you recognise one, the underlying cause is usually the second half of the line.
- Visible gap between the hinge leaf and the jambThe hinge is pulling away under load.
- Commercial door binding against the frameWorn hinges or failed bearings on a heavy door with a closer.
- Hinge screws spin and will not tightenStripped screw holes in the jamb, or screws that only ever reached the jamb and not the framing.
- The door will not latch anymoreThe whole door has moved position because of hinge wear.
- The door binds only in the last inch of closingA hinge mortised too deep, pushing the door toward the strike as it comes home.
- Rust streaks below the hingesCorroding hinges, common on exterior doors that get weather.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895How conditions in Mount Vernon affect door hinge repair
Salt air is the single biggest factor on the coast. It attacks the steel inside roller bearings, hinge pins, latch mechanisms and closer springs, and it does it year round whether or not a storm ever comes.
A gust catching an open door and slamming it against its stop puts an enormous shock load through the top hinge, and that single event is often what starts a sag that develops over the following months.
Grit in a hinge knuckle grinds the pin and the barrel every time the door swings, and a hinge that squeals in a sandy environment is usually already worn oval inside.
None of it is a reason to replace a door. It is a reason to use the right parts and set the door up correctly in the first place.
Local factors we account for in Mount Vernon: storm wind and blowing sand — typical of the Alabama Gulf Coast.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895What we repair
- Spring hinge adjustmentSetting self-closing spring hinges to the right tension.
- Pin and knuckle serviceReplacing worn pins, adding tips, and dealing with hinges that have worn oval.
- Ball bearing hinge upgradeBearing hinges for heavy doors and doors fitted with closers.
- Long-screw anchoringRunning fasteners through the jamb into the structural framing so the hinge holds the real load.
- Hinge replacementNew hinges sized and rated to the door weight, in matching finishes.
- Mortise repairRepairing damaged or over-deep hinge mortises in door and jamb.
- Security hinge installationNon-removable pin hinges and hinge-side reinforcement on exterior doors.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895Our door hinge repair process
- Find the hinge that actually failedThe door drags at the latch, but the fault is almost always at the top hinge. We check each one under load.
- Check what the screws are holding ontoShort screws into casing rather than framing are the most common cause of sag we see, and no hinge fixes that. On the coast we also check every fastener on the opening, because salt finds plated screws long before it touches the door itself.
- Repair the mortise before the hardwareChewed or split mortises get dowelled and re-cut. Fitting a new hinge to damaged timber just moves the failure a few weeks out.
- Size the hinge to the doorA solid or fire-rated door needs hinges rated for its weight. Three light hinges on a heavy slab will always sag again.
- Re-hang and check the revealAn even gap top to bottom, latch side and hinge side, before we go anywhere near the lock.
- Confirm the lock still lines upCorrecting a sag moves the latch, so the strike is checked and adjusted as part of the same visit.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895What affects the cost of door hinge repair in Mount Vernon
What a door hinge repair job costs comes down to a handful of things, and we would rather be straight about them up front:
- whether the door also needs re-hanging or the strike relocated
- finish and security hardware selections
- standard hinges versus ball bearing or continuous hinges
- how many hinges need replacement versus repair
- whether the mortises or screw holes need rebuilding first
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Mount Vernon.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Areas we cover for door hinge repair in Mount Vernon
Coverage in Mount Vernon takes in the US-43 corridor and Main Street, plus everything around the Mount Vernon Arsenal historic site and the Mobile River.
We also cover the nearby Mobile County and the Alabama Gulf Coast communities listed further down this page.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Door hinge repair in Mount Vernon: questions we get asked
How long does hinge work take?
Straightforward hinge replacement is usually under an hour. If the mortises are damaged or the door needs re-hanging and the strike relocated, allow longer.
Are the hinges on my sliding door serviceable?
Sliding doors do not use hinges, but French and swinging patio doors do, and they are heavy. Those hinges take a lot of load and are worth checking if the door has started dragging.
How do I know which hinge is the problem?
Look at the gap between the door and the frame down the latch side. If it is tight at the top and wide at the bottom, the top hinge has pulled. That is the one carrying the most load and it fails first.
Do heavy doors need special hinges?
Yes. Solid core, exterior and commercial doors, and any door with a closer on it, should be on ball bearing hinges. Plain butt hinges on a heavy door wear out fast and take the jamb with them.
My door swings open by itself. Can that be fixed?
Yes. That means the hinge line is out of plumb, so the door is rolling downhill. Re-hanging it plumb fixes it, and in Mount Vernon it often turns up in houses where the frame has moved.
Why do my hinge screws keep coming loose?
Because they are only holding into jamb material, which is often less than an inch of soft wood. Long screws driven into the structural framing behind the jamb solve it permanently.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Other door repair services in Mount Vernon
- Sliding Door Repair Mount Vernon
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Mount Vernon
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Mount Vernon
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Mount Vernon
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Patio Door Repair Mount Vernon
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Mount Vernon
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Mount Vernon
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Mount Vernon
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Door Closer Repair Mount Vernon
Closers adjusted, rebuilt and replaced so doors shut properly instead of slamming or hanging open.
- Automatic Door Repair Mount Vernon
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Mount Vernon
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Mount Vernon
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Mount Vernon
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Mount Vernon
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Mount Vernon
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Hinge Repair near Mount Vernon
We cover the surrounding Mobile County and the Alabama Gulf Coast communities as well:
- Door Hinge Repair in Prichard
- Door Hinge Repair in Tillmans Corner
- Door Hinge Repair in Saraland
- Door Hinge Repair in Chickasaw
- Door Hinge Repair in Satsuma
- Door Hinge Repair in Theodore
- Door Hinge Repair in Semmes
- Door Hinge Repair in Citronelle
All door repair services in Mount Vernon · Door Hinge Repair across Alabama · All Alabama service areas
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895