Most of our Reform calls come from Main Street and the US-82 corridor, though we work the whole Pickens County side of it and get out to Aliceville regularly.
The mix of housing here matters for door work. Older Reform homes have wood frames and hardware worth repairing rather than replacing, while newer construction tends to have vinyl and aluminum systems where the moving parts wear out long before anything else does.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895What Reform customers call us about
These are the door closer repair faults we are called out to most often in Reform. If you recognise one, the underlying cause is usually the second half of the line.
- The door slams open against the wallBackcheck has failed or is not adjusted, and the arm and frame are taking the impact.
- The door closes fast then stops shortMismatched sweep and latch speed settings.
- Grinding from a floor closerWorn spindle or bearings in the floor unit.
- The door is very hard to push openCloser over-tensioned, often to compensate for a door that will not latch.
- The door slamsLatch speed valve out of adjustment, or a closer that has failed internally.
- There is a knock at the end of the opening swingNo backcheck, or backcheck that has failed, so the arm is bottoming out.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895What Reform weather does to door closer repair
West Alabama collects a lot of rain, and it comes in hard bursts. Doors here fail at the bottom first, where water sits against the sweep and the end grain.
Humidity swells a wood door so it drags in the frame during the final approach, and turning the closer up to overcome that makes the door punishingly heavy to open while doing nothing about the actual cause.
Water running down a door face and into a surface closer body corrodes the internals and the mounting fasteners, and a closer that has been wet repeatedly usually fails at the seal.
It is why the same repair done properly in Reform lasts, and the same repair done cheaply does not.
Local factors we account for in Reform: sustained humidity and heavy rainfall — typical of west Alabama.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Door closer repair work we handle in Reform
- Fire door closer complianceMaking sure fire-rated openings close and latch fully every time.
- Floor closer repairServicing and replacing floor-mounted closers under heavy entrance doors.
- Spring hinge and closer conversionReplacing failed spring hinges with a proper closer where the door needs it.
- Hold-open arm serviceRepairing and adjusting hold-open functions.
- Accessibility force adjustmentSetting opening force to meet accessibility requirements without losing reliable latching.
- Delayed action setupAdding delayed closing for accessibility so people have time to get through.
- Arm and bracket replacementReplacing bent arms, broken forearms and failed mounting brackets.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895How a Reform door closer repair visit works
- Watch the whole cycle, twiceOpening force, sweep speed, latch speed and backcheck. Each is a separate adjustment and each fails differently.
- Rule out the door firstA closer struggling against a binding door is not a faulty closer. Hinges and reveal get checked before we condemn the unit.
- Check for the simple faultsLoose arm fixings, a bent forearm or a seized pinion account for a lot of closers that look dead.
- Size the replacement properlyCloser size depends on door width and weight and on whether it faces exterior wind. Undersized closers fail early. We assess whether the opening has shifted before adjusting hardware, since correcting the symptom here tends not to hold.
- Set for people, not just for latchingThe door needs to close and latch every time and still be openable by someone with limited strength.
- Fit a stop where it is neededA door with no stop will destroy its own closer the first time the wind catches it.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895What affects the cost of door closer repair in Reform
What a door closer repair job costs comes down to a handful of things, and we would rather be straight about them up front:
- adjustment versus rebuild versus full replacement
- the size and weight of the door and its exposure to wind
- surface, concealed or floor mounted closer type
- whether the mounting has to be repaired or reinforced
- fire rating and accessibility compliance requirements
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Reform.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Areas we cover for door closer repair in Reform
Reform coverage runs across Main Street and the US-82 corridor, and out to the areas around the Luxapallila Creek and the Mississippi line nearby.
We also cover the nearby Pickens County and west Alabama communities listed further down this page.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Door closer repair in Reform: questions we get asked
My door does not close all the way. What is going on?
Either the closing force is too low, or the door is dragging on the frame in the last few inches. In Reform we see the second one often, because a frame that has moved makes a good closer look weak.
The closer arm on our door is bent. What causes that?
The door was opened past its limit, usually by wind catching it or by someone pushing it hard against a wall. Replacing the arm without adding an overhead stop just means it happens again.
Can you make our door easier to open for accessibility?
Yes. Opening force can be adjusted, delayed action can be added, and if the door genuinely cannot meet requirements mechanically there are power operators. Getting the mechanical adjustment right comes first.
What size closer do I need?
It depends on the door width, weight and exposure. Exterior doors in Pickens County also need to handle wind, and an undersized closer on a windy exposure gets destroyed.
There is oil dripping from my door closer. Can it be refilled?
No. Closers are sealed units, and once the seal fails the closer is finished. Refilling is not possible on standard units and the unit needs replacing.
Why is our door so heavy to open now?
Somebody has probably turned the closer up to force a door that was not latching. That is treating a symptom, and it makes the door difficult for customers and staff. Fix the latching problem and the closer can come back to a reasonable setting.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Other door repair services in Reform
- Sliding Door Repair Reform
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Reform
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Reform
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Reform
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Reform
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Reform
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Reform
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Reform
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Reform
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Automatic Door Repair Reform
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Reform
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Reform
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Reform
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Reform
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Reform
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Closer Repair near Reform
We cover the surrounding Pickens County and west Alabama communities as well:
- Door Closer Repair in Aliceville
- Door Closer Repair in Carrollton
- Door Closer Repair in Gordo
- Door Closer Repair in Northport
- Door Closer Repair in Cottondale
- Door Closer Repair in Holt
- Door Closer Repair in Coker
- Door Closer Repair in Coaling
All door repair services in Reform · Door Closer Repair across Alabama · All Alabama service areas
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895