We cover Selmont-West Selmont and the rest of Dallas County, from the US-80 corridor across to Selmont, and we are out this way often enough that Selma and Valley Grande are on the same run.
Selmont-West Selmont has enough older housing stock that repair almost always beats replacement here, and enough new construction that we spend a lot of time on hardware that failed early.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Common door closer repair faults in Dallas County
These are the door closer repair faults we are called out to most often in Selmont-West Selmont. If you recognise one, the underlying cause is usually the second half of the line.
- The door slams open against the wallBackcheck has failed or is not adjusted, and the arm and frame are taking the impact.
- Screws pulling out of the door or frameCloser mounting has failed, often because the closer was undersized for the door.
- Mounting screws have pulled the door skin outwardA closer fitted to a hollow door without a reinforcing plate.
- There is a knock at the end of the opening swingNo backcheck, or backcheck that has failed, so the arm is bottoming out.
- Oil running down the door or the wallFailed seal inside the closer body. The unit needs replacing.
- The closer arm is bentThe door has been forced open past its stop, usually by wind or by a cart.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895What Selmont-West Selmont weather does to door closer repair
The wet winter and dry late-summer cycle here is severe enough that a door adjusted perfectly in February can bind badly by September.
When a frame moves with the ground under it, the door binds somewhere in its swing, and people compensate by cranking the closer tighter, which is why so many doors are simultaneously hard to open and still not latching.
Water running down a door face and into a surface closer body corrodes the internals and the mounting fasteners, and a closer that has been wet repeatedly usually fails at the seal.
None of it is a reason to replace a door. It is a reason to use the right parts and set the door up correctly in the first place.
Local factors we account for in Selmont-West Selmont: soil movement and heavy rainfall — typical of the Black Belt.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Door closer repair work we handle in Selmont-West Selmont
- Mounting repairRepairing or reinforcing door and frame where closer fasteners have pulled out.
- Closer adjustmentSetting sweep speed, latch speed and backcheck correctly for the door and its traffic.
- Delayed action setupAdding delayed closing for accessibility so people have time to get through.
- Surface closer replacementNew surface mounted closers sized correctly for door width and weight.
- Wind and stop protectionFitting overhead stops so wind cannot destroy the closer arm.
- Concealed closer serviceOverhead concealed closers in aluminum storefront doors repaired or replaced.
- Accessibility force adjustmentSetting opening force to meet accessibility requirements without losing reliable latching.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895How a Selmont-West Selmont door closer repair visit works
- Watch the whole cycle, twiceOpening force, sweep speed, latch speed and backcheck. Each is a separate adjustment and each fails differently.
- Rule out the door before blaming the closerA door binding on the frame makes a perfectly good closer look weak, and turning the closer up is the wrong answer.
- Check for the simple faultsLoose arm fixings, a bent forearm or a seized pinion account for a lot of closers that look dead.
- Size the replacement properlyDoor width, weight and exposure decide the power size. An undersized closer will not shut the door; an oversized one shuts out anyone who is not strong.
- Set for people, not just for latchingThe door needs to close and latch every time and still be openable by someone with limited strength. On prairie clay we look at the whole opening for racking, because a door here is usually reporting a foundation movement rather than a hardware fault.
- Fit a stop where it is neededA door with no stop will destroy its own closer the first time the wind catches it.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895What affects the cost of door closer repair in Selmont-West Selmont
Pricing on door closer repair depends on what has actually failed, which is why we talk it through before quoting. These are the things that move the number:
- surface, concealed or floor mounted closer type
- adjustment versus rebuild versus full replacement
- the size and weight of the door and its exposure to wind
- adding overhead stops or hold-open functions
- whether the mounting has to be repaired or reinforced
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Selmont-West Selmont.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895Areas we cover for door closer repair in Selmont-West Selmont
Selmont-West Selmont coverage runs across the US-80 corridor and Selmont, and out to the areas around the Alabama River and the Edmund Pettus Bridge.
We also cover the nearby Dallas County and the Black Belt communities listed further down this page.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Door closer repair in Selmont-West Selmont: questions we get asked
What size closer do I need?
It depends on the door width, weight and exposure. Exterior doors in Dallas County also need to handle wind, and an undersized closer on a windy exposure gets destroyed.
How long do door closers last?
A good quality closer on a properly hung door can run for well over a decade. A cheap closer on a heavy exterior door in Selmont-West Selmont might last a couple of years, especially if it is fighting a misaligned door.
Do door closers need different settings in summer and winter?
They can. The hydraulic fluid thins in heat and thickens in cold, so a closer set perfectly in Selmont-West Selmont in August may close too slowly in January. Quality closers hold their setting better across the temperature swing.
There is oil dripping from my door closer. Can it be refilled?
No. Closers are sealed units, and once the seal fails the closer is finished. Refilling is not possible on standard units and the unit needs replacing.
Do you work on floor closers?
Yes. Floor closers under heavy entrance doors are serviceable, though they are more involved to work on because the unit sits in the floor.
My door slams every time. Can that be adjusted?
Almost always. There is a latch speed valve on the closer that controls the last few inches, and it has probably drifted or been set wrong. Adjusting it takes minutes and saves your frame, hinges and hardware from a lot of abuse.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Other door repair services in Selmont-West Selmont
- Sliding Door Repair Selmont-West Selmont
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Selmont-West Selmont
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Selmont-West Selmont
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Selmont-West Selmont
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Selmont-West Selmont
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Selmont-West Selmont
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Selmont-West Selmont
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Selmont-West Selmont
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Selmont-West Selmont
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Automatic Door Repair Selmont-West Selmont
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Selmont-West Selmont
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Selmont-West Selmont
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Selmont-West Selmont
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Selmont-West Selmont
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Selmont-West Selmont
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Closer Repair near Selmont-West Selmont
We cover the surrounding Dallas County and the Black Belt communities as well:
- Door Closer Repair in Selma
- Door Closer Repair in Valley Grande
- Door Closer Repair in Moundville
- Door Closer Repair in Livingston
- Door Closer Repair in York
- Door Closer Repair in Butler
- Door Closer Repair in Eutaw
- Door Closer Repair in Greensboro
All door repair services in Selmont-West Selmont · Door Closer Repair across Alabama · All Alabama service areas
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895