Frisco City sits in Monroe County, and our work here runs from Main Street out past the Frisco City depot, with Monroeville and Daphne close enough that we are usually in the area anyway.
A lot of what we see in Monroe County comes down to age. Houses built decades ago have solid frames with tired hardware; houses built recently have sound hardware in frames that are still settling.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895The door frame repair problems we see most in Frisco City
These are the door frame repair faults we are called out to most often in Frisco City. If you recognise one, the underlying cause is usually the second half of the line.
- A hinge screw goes in but never gets tightThe screw is turning in decayed wood or in an over-drilled hole with nothing left to bite.
- The frame moves when the door slamsThe frame is no longer solidly fastened to the rough opening.
- The jamb sounds hollow when you tap itRot that has consumed the core while the paint film outside still looks intact.
- Fresh paint blisters at the jamb foot within a seasonMoisture driving out from inside the timber, which means the source has not been dealt with.
- Daylight under the thresholdThe sill has deteriorated or the threshold has come loose from the subfloor.
- Gaps between the jamb and the wallThe frame has pulled loose from the framing behind it, or the fasteners have lost their grip.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Why door frame repair fails in the Alabama Gulf Coast
Between roughly 65 inches of rain a year, near-constant humidity and a June-to-November hurricane season, coastal doors work harder than doors anywhere else in Alabama.
Sand piling against a sill holds moisture against the bottom of the jamb the same way mulch does, and the rot that follows starts at the very bottom of the leg where nobody looks until the wood is already soft.
Heavy rainfall overwhelms whatever drainage exists at a threshold, and if there is no sill pan under the frame the water goes into the framing and the subfloor, so what shows up as a soft jamb is usually the smallest part of the problem.
None of it is a reason to replace a door. It is a reason to use the right parts and set the door up correctly in the first place.
Local factors we account for in Frisco City: blowing sand and heavy rainfall — typical of the Alabama Gulf Coast.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895What a door frame repair call covers
- Full frame replacementWhen the damage is beyond repair, replacing the frame without disturbing more of the wall than necessary.
- Hinge jamb repairRepairing stripped hinge mortises so the screws hold again.
- Water management detailsFlashing, drip caps and sill pans so the repair does not rot out again.
- Jamb splicing and dutchman repairsCutting out the damaged section and letting in new material rather than replacing the whole leg.
- Steel and commercial frame repairRepairing hollow metal frames, anchors and welded joints.
- Strike jamb reinforcementSteel strike boxes and long screws into the framing to make a forced-entry repair stronger than the original.
- Threshold and sill replacementNew adjustable thresholds and sill pans so water drains out instead of in.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895How we approach door frame repair
- Find out what moved and whyWe check plumb, level and square across the opening and look for the cause, because a frame that is out of square because the foundation moved will go out of square again.
- Probe for the real extent of the rotDamaged wood is almost always larger than what shows. We find sound material before deciding on a repair.
- Be straight about repair versus replacementSome jambs are worth splicing and some are past it. We tell you which this is rather than defaulting to the bigger job.
- Rebuild in material that survives hereTreated timber, composite or a full jamb depending on exposure. Untreated pine at a wet sill is a repair with an expiry date.
- Reset the door to the repaired frameConsistent reveal, correct hinge alignment and a latch that engages without pressure. We check the drainage path on every coastal opening, because wind-driven rain gets in where ordinary rain never would.
- Seal it so it stays sealedCorrect sealant at the correct joints, and paint or finish onto sound substrate so water has nowhere to start again.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895What affects the cost of door frame repair in Frisco City
We would rather tell you what drives the price than quote a number that turns out to be wrong once we see the door. On a door frame repair job in Frisco City, the main variables are these:
- whether the cause is structural movement that needs to be addressed first
- whether the frame can be spliced or has to be replaced
- whether the threshold and sill pan also need rebuilding
- how far the rot or damage extends into the frame and framing
- wood versus hollow metal frames on commercial openings
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Frisco City.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Areas we cover for door frame repair in Frisco City
Our Frisco City service area includes Main Street and the AL-21 corridor and the surrounding Monroe County communities, out around the Frisco City depot and Monroeville just north.
We also cover the nearby Monroe County and the Alabama Gulf Coast communities listed further down this page.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Door frame repair in Frisco City: questions we get asked
Someone kicked in my door. Can the frame be saved?
Usually yes, and it can be made stronger than it was. Most kick-ins split the jamb at the strike because the original screws only went into thin jamb material. We rebuild the split and reinforce it into the structural framing behind.
How do I know if the damage is rot or termites?
Rot is soft and spongy and follows water paths from the bottom up. Insect damage leaves galleries and frass. Either way the moisture problem that let it start needs fixing, or the repair will not last in Monroe County.
Why does the bottom of my door frame keep rotting out?
Water is getting to it and staying there. That means a failed threshold, a missing sill pan, a drip cap that is not shedding water, or ground and mulch sitting too high against the sill. Replacing the wood without fixing the water just resets the clock.
My frame is fine but the door still will not shut. What else could it be?
Hinges, the door slab itself swelling, or a strike that has moved. We check the whole opening rather than assuming, because misdiagnosing this is how people end up buying a door they did not need.
Do you repair metal commercial door frames?
Yes. Hollow metal frames in Frisco City businesses get damaged at the strike, at the floor anchors and around the hinges, and all three are repairable without replacing the whole frame.
Is it worth repairing a frame on an old house?
Usually very much so. Old growth jamb material is better than most of what you can buy now, and splicing preserves the original profile and casing rather than replacing it with a modern lookalike.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Other door repair services in Frisco City
- Sliding Door Repair Frisco City
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Frisco City
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Handle Repair Frisco City
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Frisco City
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Frisco City
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Frisco City
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Frisco City
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Frisco City
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Door Closer Repair Frisco City
Closers adjusted, rebuilt and replaced so doors shut properly instead of slamming or hanging open.
- Automatic Door Repair Frisco City
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Frisco City
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Frisco City
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Frisco City
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Frisco City
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Frisco City
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Frame Repair near Frisco City
We cover the surrounding Monroe County and the Alabama Gulf Coast communities as well:
- Door Frame Repair in Monroeville
- Door Frame Repair in Daphne
- Door Frame Repair in Fairhope
- Door Frame Repair in Foley
- Door Frame Repair in Gulf Shores
- Door Frame Repair in Orange Beach
- Door Frame Repair in Spanish Fort
- Door Frame Repair in Bay Minette
All door repair services in Frisco City · Door Frame Repair across Alabama · All Alabama service areas
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895