Our territory takes in Frisco City and the communities around it in Monroe County, so calls from Main Street, the AL-21 corridor and out by the Frisco City depot all get the same response.
Between the established parts of Frisco City and the newer subdivisions, we see two different kinds of failure: worn-out frames on one side of town and worn-out hardware on the other.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Common storefront door repair faults in Monroe County
These are the storefront door repair faults we are called out to most often in Frisco City. If you recognise one, the underlying cause is usually the second half of the line.
- The bottom rail has dropped and the corner is out of squareFailed corner fasteners in the rail, which is the most common storefront failure by a distance.
- Broken storefront glassImpact or break-in damage requiring board-up and tempered replacement.
- The concealed closer in the floor has slowed noticeablyContamination or fluid loss in the floor unit, which needs the door lifted to reach.
- The closer leaks oil or has stopped closing the doorFailed concealed overhead or floor closer.
- Customers have to pull hard to open the doorOver-tensioned closer, worn pivots or a door binding in the frame.
- The bottom rail is loose or has separatedThe rail-to-glass connection has failed, which is common on older entrances.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895What we see on storefront door repair around Monroe County
Blowing sand gets into everything down here. Tracks, screen channels, thresholds and lock cylinders all collect it, and it acts like sandpaper on moving parts.
Driving rain gets under a storefront door with a worn sweep and across the floor inside, and the water that collects in the threshold corrodes the bottom pivot housing.
Grit accumulates in the bottom pivot and the threshold of an aluminum entrance and grinds the bearing surface, and on a storefront that sees hundreds of cycles a day that wear happens quickly.
None of it is a reason to replace a door. It is a reason to use the right parts and set the door up correctly in the first place.
Local factors we account for in Frisco City: heavy rainfall and blowing sand — typical of the Alabama Gulf Coast.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895Our storefront door repair services in Frisco City
- Emergency board-up and securingSame-day securing so a business can lock up.
- Pivot and hinge replacementTop and bottom pivots, offset pivots and continuous hinges on aluminum entrances.
- Weatherstrip and meeting stile sealsNew seals on pairs of doors and along jambs.
- Push and pull hardwareReplacing handles, push bars and offset pulls, including ADA-compliant hardware.
- Storefront glass replacementTempered glass replacement for doors, sidelites and transoms.
- Door alignment and squaringBringing a dropped or racked storefront door back to correct alignment.
- Closer repair and replacementConcealed overhead, surface and floor closers repaired or replaced and correctly adjusted.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895How a Frisco City storefront door repair visit works
- Start at the pivotAlmost every storefront complaint traces back to the top or bottom pivot. That is where we look before touching the closer.
- Test the closer on its ownDisconnecting the arm tells us instantly whether the door is heavy or the closer is failing. They need different work.
- Secure before we finishIf the deadlatch or the cylinder is the problem, the door is made lockable before we leave, whatever else is outstanding.
- Square the door back upCorner fasteners get pulled up, the rail is reset, and the door is brought back square before the pivot is adjusted. On the coast we also check every fastener on the opening, because salt finds plated screws long before it touches the door itself.
- Set the closer to codeOpening force and closing speed adjusted for accessibility and for the actual traffic through the door.
- Fit around your tradingEarly, late or midweek. We would rather work around a shop than shut a doorway during the busiest part of the day.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895What affects the cost of storefront door repair in Frisco City
What a storefront door repair job costs comes down to a handful of things, and we would rather be straight about them up front:
- glass replacement and whether board-up is needed first
- frame damage from forced entry
- whether the pivots, closer, or both need replacing
- concealed and floor closers versus surface mounted units
- hardware grade and ADA compliance requirements
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Frisco City.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Areas we cover for storefront door repair in Frisco City
We work throughout Frisco City, including Main Street and the AL-21 corridor. If you are near the Frisco City depot and Monroeville just north, that is inside our normal service area.
We also cover the nearby Monroe County and the Alabama Gulf Coast communities listed further down this page.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Storefront door repair in Frisco City: questions we get asked
Our front door will not lock at night. Can you come today?
That is exactly the call to make immediately. A Frisco City business that cannot secure its front entrance has a real problem, and getting the deadlatch working again is usually straightforward once we see it.
Someone broke in and bent the frame. Is it repairable?
In most cases. Aluminum frames damaged at the lock and strike can be straightened and reinforced. We secure the opening first and then do the permanent repair.
Why is our door so hard for customers to open?
Usually the closer has been cranked up to force a misaligned door to latch. That is treating the symptom. Fix the alignment and the closer can go back to a comfortable setting that still latches.
Do you work on pairs of doors and automatic entrances?
Yes, both. Pairs need coordinated alignment so the astragal seals and both leaves latch, and we service automatic operators as well.
The bottom rail of our door is coming loose. Is that serious?
Yes. The bottom rail holds the glass. Once its connection loosens, the glass is no longer properly supported and the door is on borrowed time.
Water comes under our front door when it storms. What fixes that?
A new sweep and threshold seal, and sometimes correcting the drainage at the entrance. In Monroe County storms drive water horizontally, so the seal has to work under pressure, not just gravity.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Other door repair services in Frisco City
- Sliding Door Repair Frisco City
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Frisco City
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Frisco City
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Frisco City
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Frisco City
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Frisco City
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Frisco City
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Frisco City
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Door Closer Repair Frisco City
Closers adjusted, rebuilt and replaced so doors shut properly instead of slamming or hanging open.
- Automatic Door Repair Frisco City
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Frisco City
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Frisco City
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Frisco City
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Frisco City
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Frisco City
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Storefront Door Repair near Frisco City
We cover the surrounding Monroe County and the Alabama Gulf Coast communities as well:
- Storefront Door Repair in Monroeville
- Storefront Door Repair in Daphne
- Storefront Door Repair in Fairhope
- Storefront Door Repair in Foley
- Storefront Door Repair in Gulf Shores
- Storefront Door Repair in Orange Beach
- Storefront Door Repair in Spanish Fort
- Storefront Door Repair in Bay Minette
All door repair services in Frisco City · Storefront Door Repair across Alabama · All Alabama service areas
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895