We service every part of Saraland, including the Industrial Parkway corridor and the Shelton Beach Road area, and the nearby Mobile County towns like Prichard and Tillmans Corner.
The mix of housing here matters for door work. Older Saraland homes have wood frames and hardware worth repairing rather than replacing, while newer construction tends to have vinyl and aluminum systems where the moving parts wear out long before anything else does.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Common door closer repair faults in Mobile County
These are the door closer repair faults we are called out to most often in Saraland. If you recognise one, the underlying cause is usually the second half of the line.
- Mounting screws have pulled the door skin outwardA closer fitted to a hollow door without a reinforcing plate.
- Different behavior in summer and winterFluid viscosity changing with temperature, which needs seasonal adjustment or a temperature-stable closer.
- Oil running down the door or the wallFailed seal inside the closer body. The unit needs replacing.
- The door does not close the last inchClosing force is too low, or the door is binding on the frame in the final approach.
- The door closes at a good speed then slams the last inchLatch speed set too fast, or a worn valve that no longer holds the latch adjustment.
- The door slams open against the wallBackcheck has failed or is not adjusted, and the arm and frame are taking the impact.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895Why door closer repair fails in the Alabama Gulf Coast
Between roughly 65 inches of rain a year, near-constant humidity and a June-to-November hurricane season, coastal doors work harder than doors anywhere else in Alabama.
Salt air corrodes closer arm pivots and the exposed spindle where it enters the closer body, and once that seal is compromised the closer starts weeping oil and its life is effectively over.
Wind is the main killer of door closers: a gust drives the door past its opening limit, bends the arm and often tears the mounting out of the door, which is why an overhead stop is not optional on an exposed door.
We factor that in on every door closer repair job around the Saraland civic complex and the rest of Saraland.
Local factors we account for in Saraland: salt air and storm wind — typical of the Alabama Gulf Coast.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Door closer repair work we handle in Saraland
- Hold-open arm serviceRepairing and adjusting hold-open functions.
- Spring hinge and closer conversionReplacing failed spring hinges with a proper closer where the door needs it.
- Surface closer replacementNew surface mounted closers sized correctly for door width and weight.
- Closer adjustmentSetting sweep speed, latch speed and backcheck correctly for the door and its traffic.
- Delayed action setupAdding delayed closing for accessibility so people have time to get through.
- Wind and stop protectionFitting overhead stops so wind cannot destroy the closer arm.
- Floor closer repairServicing and replacing floor-mounted closers under heavy entrance doors.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Our door closer repair process
- Time the closeA door that shuts in under five seconds or fails to latch tells us which valve is at fault before the cover comes off.
- Rule out the door before blaming the closerA door binding on the frame makes a perfectly good closer look weak, and turning the closer up is the wrong answer.
- Adjust before replacingMany closers we are called to are serviceable and simply out of adjustment. That is a much smaller job and we say so.
- Size the replacement properlyDoor width, weight and exposure decide the power size. An undersized closer will not shut the door; an oversized one shuts out anyone who is not strong.
- Set for people, not just for latchingThe door needs to close and latch every time and still be openable by someone with limited strength.
- Fit a stop where it is neededA door with no stop will destroy its own closer the first time the wind catches it. On the coast we also check every fastener on the opening, because salt finds plated screws long before it touches the door itself.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895What affects the cost of door closer repair in Saraland
What a door closer repair job costs comes down to a handful of things, and we would rather be straight about them up front:
- the size and weight of the door and its exposure to wind
- adding overhead stops or hold-open functions
- adjustment versus rebuild versus full replacement
- surface, concealed or floor mounted closer type
- fire rating and accessibility compliance requirements
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Saraland.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Areas we cover for door closer repair in Saraland
Coverage in Saraland takes in the Industrial Parkway corridor, the Shelton Beach Road area and Kali Oka, plus everything around the Saraland civic complex, the I-65 interchange and the Mobile River industrial corridor.
We also cover the nearby Mobile County and the Alabama Gulf Coast communities listed further down this page.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Door closer repair in Saraland: questions we get asked
Do you work on floor closers?
Yes. Floor closers under heavy entrance doors are serviceable, though they are more involved to work on because the unit sits in the floor.
My door slams every time. Can that be adjusted?
Almost always. There is a latch speed valve on the closer that controls the last few inches, and it has probably drifted or been set wrong. Adjusting it takes minutes and saves your frame, hinges and hardware from a lot of abuse.
My door does not close all the way. What is going on?
Either the closing force is too low, or the door is dragging on the frame in the last few inches. In Saraland we see the second one often, because a frame that has moved makes a good closer look weak.
Do door closers need different settings in summer and winter?
They can. The hydraulic fluid thins in heat and thickens in cold, so a closer set perfectly in Saraland in August may close too slowly in January. Quality closers hold their setting better across the temperature swing.
How long do door closers last?
A good quality closer on a properly hung door can run for well over a decade. A cheap closer on a heavy exterior door in Saraland might last a couple of years, especially if it is fighting a misaligned door.
Why is our door so heavy to open now?
Somebody has probably turned the closer up to force a door that was not latching. That is treating a symptom, and it makes the door difficult for customers and staff. Fix the latching problem and the closer can come back to a reasonable setting.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895Other door repair services in Saraland
- Sliding Door Repair Saraland
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Saraland
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Saraland
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Saraland
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Saraland
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Saraland
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Saraland
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Saraland
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Saraland
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Automatic Door Repair Saraland
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Saraland
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Saraland
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Saraland
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Saraland
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Saraland
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Closer Repair near Saraland
We cover the surrounding Mobile County and the Alabama Gulf Coast communities as well:
- Door Closer Repair in Prichard
- Door Closer Repair in Tillmans Corner
- Door Closer Repair in Chickasaw
- Door Closer Repair in Satsuma
- Door Closer Repair in Theodore
- Door Closer Repair in Semmes
- Door Closer Repair in Citronelle
- Door Closer Repair in Grand Bay
All door repair services in Saraland · Door Closer Repair across Alabama · All Alabama service areas
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895